Kenton Modular Solo Manual do Utilizador descarregar pdf (Página 11)

P 52 AUX 3 maximum value (default: 100)

- Sets the level for the Auxiliary output when the MIDI controller source is at its maximum.

Range 0 to +100

A value of 10 is approximately 1 volt – so 100 is approx. 10 volts.

Note that minimum can be set above maximum so that the controller works backwards.

P 53 AUX 3 reset value (default: 0)

Range 0 to 127

- Sets the level the Auxiliary output will reset to when the MODULAR SOLO is powered on or when it

receives a controller reset MIDI command or a new setup is loaded from memory. This is equivalent to

a MIDI message of this value being received, so it will be influenced by min and max settings above.

AUX4 output

P 60 AUX 4 controller number (default: Aftertouch)

- Sets which MIDI controller will control the auxiliary output. The following can be selected:

Off [oFF]

Pitch bend [Pbd]

Velocity [VEL]

Aftertouch [AFt]

MIDI controllers 0-119

P 61 AUX 4 minimum value (default: 0)

- Sets the level for the Auxiliary output when the MIDI controller source is at its minimum.

Range 0 to +100

A value of 10 is approximately 1 volt – so 100 is approx. 10 volts.

Note that minimum can be set above maximum so that the controller works backwards.

P 62 AUX 4 maximum value (default: 100)

- Sets the level for the Auxiliary output when the MIDI controller source is at its maximum.

Range 0 to +100

A value of 10 is approximately 1 volt – so 100 is approx. 10 volts.

Note that minimum can be set above maximum so that the controller works backwards.

P 63 AUX4 reset value (default: 0)

Range 0 to 127

- Sets the level the Auxiliary output will reset to when the MODULAR SOLO is powered on or when it

receives a controller reset MIDI command or a new setup is loaded from memory. This is equivalent to

a MIDI message of this value being received, so it will be influenced by min and max settings above.

CLOCK1 output

P 70 Clock1 type (default: clock normal)

- Sets which MIDI controller will control AUX2 output. The following controllers can be selected:

Clock normal [cLn]

Clock inverted [cLi]

Stop/start normal [SSn]

Stop/start inverted [SSi]

The ON voltage can be set using parameter 73 – clock1 voltage.

Inverted settings mean that on is zero and off is high. (like s-trig).

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Sem comentários

Kenton Modular Solo Manual do Utilizador Página 11